Why does the wallpaper lie obliquely on the wall and how to fix it
Wallpapering is a rather complicated procedure that requires an increased concentration of attention.
Sometimes the wallpaper does not fit the way you want. Often people are perplexed about the bumps that appear after pasting. And to fix this is quite problematic.
In most cases, the problem is in the walls. Before repair, they must be aligned.
This article will discuss the main causes of such defects, as well as methods for their elimination.
Wallpaper lags the bottom of the wall
Usually this circumstance arises due to the fact that the wall was poorly smeared during the pasting. Do not regret the glue.
Wallpaper itself also needs to be carefully lubricated. In addition, do not forget to press them against the wall and smooth them with a construction roller.
This issue is fixed quite easily. Poorly pressed corners of wallpaper should be bent and smeared with adhesive.
Then press them against the surface of the wall. You can use a towel to get the best result.
Wallpaper lay askew
This defect often occurs due to the roughness of the walls themselves. Before starting repair work, it is necessary to align the walls.
For this purpose, you can hire specially trained people who can cope with the task in a few hours.
In case the problem is noticed after wallpapering, everything is much more complicated.
In this situation, there are two options: either re-glue again, or try to minimize irregularities. the second option is considered the most preferred.
The defect must be out of the reach of the eye. Irregularities cannot be avoided. However, it can be hidden behind furniture, for example, in the corner where the cupboard stands.
Wallpaper stitches are too big and wide
This problem usually occurs if new wallpapers were pasted over old ones. When performing this procedure, mismatch of the seams is ensured.
It is also possible that the wallpaper was not pressed during wall pasting. However, this action requires implementation.
Note! Before pasting wallpaper, you must carefully clean the walls of the old layer.
Thanks to this, the service life of the wallpaper will increase significantly. If for some reason it is not possible to completely clean the wall, then at least the seams on the old wallpaper should be removed.
When pasting the room, without fail, press the wallpaper seams.
Thanks to this action, the probability of obtaining a satisfactory result will increase several times.
If the walls were not cleaned, then you can use the method that will save a person from the full plywood wallpaper.
The seams of the wallpaper must be wet using a damp cloth. Next, take a small rag, lay it on the seam and tap it along its entire length with a hammer.
However, this procedure should be resorted to only as a last resort. The main thing is to carry out the work very carefully.
Thus, in today's article, the main defects that may occur when working with wallpaper were presented.
Are you ready to follow the recommendations in the article?