How to properly process a wooden floor in a bath from mold and rot

Bathhouse - a room with a specific microclimate. Constant high humidity can provoke the development of mold and mildew on wooden surfaces. At the same time, harmful spores that harm the human body will be present in the air. You can deal with mold and fungus on a wooden floor with special solutions.

Places where mold and fungus appear most often

Most often, the floors in the steam room are damaged by mold. This room often does not have windows, so it is difficult to ventilate. There is also a high probability of the spread of harmful microorganisms in the dressing room. This room is used to relax after the steam room, so it is always warm and damp.

The first signs of mold and fungus on the floor surface are most often manifested in such places:

• Around the shower tray.
• In the corners of the rooms.
• Between the joints of the boards.
• Under the furniture.

Ways to fight

The fight against mold must begin immediately after it is detected. You can’t let it spread, because it not only threatens the healthy atmosphere in the bath, but also destroys the structure itself.

First you need to ventilate and dry the room as well as possible. To do this, open all windows and doors, as well as turn on the fans. This will enhance the movement of air masses.

While the bath is being ventilated, it is necessary to carefully inspect the floor surface and mark all damaged areas. Next, pre-processing. In doing so, consider the following:

• If damage to the floor boards is barely noticeable, then they are immediately treated with a special tool.
• If the foci of damage are large, then the mold must be cleaned with a spatula and a metal brush, and only then handle the composition

It is necessary to process not only the damaged area, but also to capture the area around it at a distance of at least 30 cm. The procedure requires care. All actions must be carried out strictly in accordance with the instructions of the manufacturer of the product used.

After the mold is killed, it must be cleaned again with a spatula. After that, wash the floor with clean water.

In addition to ready-made store products, you can use compositions made from the components that are available in every home. Of course, they are less effective. But as a temporary protection in order to prevent the spread of harmful organisms, it is quite reasonable to use them.

Effective is a solution of salt and boric acid. Dosage: 1 kg of salt and 50 g of boric acid are dissolved in 5 l of water. The solution treats damaged areas several times with a frequency of approximately 1.5 to 2 hours.

A well-known folk method used to combat mold is the following procedure:

• Places damaged by mold are covered with baking soda.
• Vinegar is sprayed onto the areas filled with soda.
• After a few hours, the floors are swept and washed.

In order to reduce the risks of mold and mildew in the bathhouse, it is necessary to ventilate the premises as often as possible. It is advisable to install forced ventilation systems to maintain a healthy atmosphere.

If one of the readers can offer simpler ways to combat mold, I would like to meet them in our forum.